ECM Switch table - Monodax MXScan (Tunercat / Jet DST) OBDII Support

		Monodax MXScan (Tunercat / Jet DST) OBDII Support > TunerCat Discussion > TunerCat OBDI Hardware and Software
ECM Switch table

TunerCat OBDI Hardware and Software General Discussion about TunerCat's OBDI product line

LinkBack

Thread Tools

Display Modes

#1 (permalink)

08-11-2007, 03:02 PM

C_Rules

Senior Member

Join Date: Apr 2007

Posts: 151

ECM Switch table

I noticed that in the ECM swtich tables the transmission slip (DTC 80) and the fan 2 diagnostic (DTC 78) are not selected. Anybody know why? If i have a 3K stall will this constantly trigger an DTC error if I enable it?

« Newbie speedo/fried brain ? etc help | obd1 Data Logger »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
VE table needs more kpa	solowma	TunerCat / JET OBDII Hardware and Software	5	08-02-2007 10:01 AM
VE table	SILVERGS	TunerCat / JET OBDII Hardware and Software	4	07-05-2007 01:34 AM
95 LT1 PCM (EE) switch to manual trans?	LittleNo	TunerCat OBDI Hardware and Software	2	06-21-2007 11:25 PM
Table Help	PartsGuy	TunerCat / JET OBDII Hardware and Software	4	07-03-2005 02:45 PM
"Tow/Haul Mode" Calibration Switch?	cbattles	TunerCat / JET OBDII Hardware and Software	1	05-31-2005 02:10 PM

All times are GMT -4. The time now is 08:56 PM.