Hey

[durbo.jones]

I am new to this stuff. I rebuilt the engine In my 91 K2500 and need to fine tune it for the cam and heads. It is really sluggish below 2500 RPMs. I put a set of stock Vortec heads on it along with a Edelbrock Performer Intake, and a set of 1 5/8" Intermediate length Headers. I used a Crane Powermax cam (.440/.454 lift 210/216 duration @.050 with an advertised duration of 270/276). I am looking for ideas of where to start or if anyone has done a setup similar to this.

Josh

[s10mods]

Are you still running the TBI setup?

[durbo.jones]

yeah, Stock computer and throttle body.

[s10mods]

Do you have anything to program it with? That computer has a chip that you will have to burn and replace. If not, check out moates.net, and tunercat.com they have the stuff you will need. I believe that there are real time emulators out there for those also.

[durbo.jones]

Yes I bought a programmer for the eproms, an emulator, and some extra eproms. I downloaded the TunerCat RT onto my laptop. I have everything I need to start programming.

[playtoy_18]

hahaha
everything but the hour's upon hour's upon hour's upon hours upon...x infinity
that it take's to figure this stuff out....lol
Good luck,don't be afraid to ask question's,just be afraid of the answer's..